How MOD-9 was made
Share
MOD-9 is modeled on the Roland TR-909. It started with one 909 in our studio, a machine from late in the production run, and one question for every sound: does it do what that 909 does?
Recorded from the real machine
We played our 909 and recorded it, then played MOD-9 the same notes, so every hit could be laid next to the real one. We did that for every drum, from the softest hits to the loudest, and for the flams, rolls and ghost notes a drum part is made of.
Every knob, end to end
A knob on a 909 does not move the sound in a straight line. We recorded each one from fully left to fully right: tune, decay, attack, tone, snappy, level and volume. MOD-9's knobs follow those curves, and they turn without steps.
Built from the circuit
The 909's drums are analog circuits, and MOD-9's drums follow its schematic. A few parts changed while the 909 was in production, the rim shot's and the hi-hats' among them. MOD-9 has the later parts, as in our machine, and an OLD REV switch brings the earlier ones back.
The quirks stay in
Some of what makes a 909 sound like a 909 is not printed on the panel. A soft ride hit pulls a ringing crash down with it, because the two share one volume. The snare's fizz holds for a moment, then stops. The drums' jacks carry a slow swing under every hit. A clap played right after another comes out a little louder, its bursts a little later. Velocity does not move smoothly but in steps, one level for a run of velocities, with a jump on the snare and a small dip near the top. The machine answers MIDI a few milliseconds late, never quite the same twice, and a quiet hiss and hum sit underneath it all.
MOD-9 has each of these. The ones you may not always want sit on a switch or a knob: CYM LINK, VELO STEPS, TIMING and NOISE FLOOR.
What came out
Along the knobs, MOD-9's level stays within half a decibel of our 909, and it follows each sound's velocity steps within a few tenths of a decibel; only the clap, which varies from hit to hit on the 909 itself, stays within about one.
